Zenith V3.0
Specs:

Weight : 150g
Dimensions : 150x130x70
Wheels: 20mm Diameter Lego Wheels
Drive Motors :Sanyo 75:1 Gearmotors
Drive ESC : Sozbots MX
Weapon Motor : NC-4 Stinger
Weapon ESC : Sozbots MX
Reciever : Hitec Feather
Power : 12.6v 340mah 3-cell Lipo pack
Chassis : 1 & 2mm Polycarbonate
Armor : None as such
Disk Info : 80mm Diamater, 35g, Stanley Knife blades
Status : Upgraded
Dimensions : 150x130x70
Wheels: 20mm Diameter Lego Wheels
Drive Motors :Sanyo 75:1 Gearmotors
Drive ESC : Sozbots MX
Weapon Motor : NC-4 Stinger
Weapon ESC : Sozbots MX
Reciever : Hitec Feather
Power : 12.6v 340mah 3-cell Lipo pack
Chassis : 1 & 2mm Polycarbonate
Armor : None as such
Disk Info : 80mm Diamater, 35g, Stanley Knife blades
Status : Upgraded
Information:
After much thinking and trying to come up with a better design for a vertical spinner, I took a page out of Nightmare's book, and started trying to design something with wheels at the front, but with nothing near the disk at the front. While my origional designs didn't look like Nightmare at all, as I refined them they gradually looked more and more like it, but it was never intentional. This version of Zenith worked very nicely, it was fast, manouverable, and the disk was quite powerful, however it was drawn against Militant in it's 2nd fight, and the stanley knife blades were snapped, the supports bent, the disk sliced through the motor housing, and it did a dance and threw itself out. I clearly needed to make my robots a lot stronger to withstand the forces of the large, powerful disk I was using.