Epic Robotics
  • Home
  • Robots
    • Void>
      • Void V9.0
      • Old Versions
    • Zenith>
      • Zenith V5.1
      • Zenith V5.0
      • Old Versions
    • Flux>
      • Flux V1.0
    • EP>
      • EP V2.0
      • EP V1.0
  • Events
  • Links
  • Contact

Zenith 2.0

Specs:

Picture
Weight : 150g
Dimensions : 90x100x75mm
Wheels: 52mm Diameter Foam Wheels
Drive Servos : Picos
Weapon Motor : NC-4 Stinger
Weapon ESC : Jes 110
Reciever : Hitec Feather
Power : 12.6v 340mah 3-cell Lipo pack
Chassis : 1 & 2mm Polycarbonate
Armor : None as such
Disk Info : 80mm Diamater, 35g, Stanley Knife blades
Status : Retired

Information:

As most of you know, Zenith 1.0 was a vertical spinner. Me being me, I had left it until 1 or 2 nights before the event to start working on the new version of Zenith, which was going to be very similar to the old one, just with an extra support so it wouldn't fall over. However, after cutting out the main chassis frames, I realised a flaw in the design, and that it just wasn't going to work, so i chopped the front arms off, put a wedge on, and mounted the disk at an angle, horizontally, onto that. This version of Zenith actually did suprisingly well (probably the best so far), However I still really wanted a vertical spinner, so I reverted back to one as soon as I could.
Powered by Create your own unique website with customizable templates.