Epic Robotics
  • Home
  • Robots
    • Void>
      • Void V9.0
      • Old Versions
    • Zenith>
      • Zenith V5.1
      • Zenith V5.0
      • Old Versions
    • Flux>
      • Flux V1.0
    • EP>
      • EP V2.0
      • EP V1.0
  • Events
  • Links
  • Contact

Zenith V1.0

Specs:

Picture
Weight : 150g
Dimensions : 120x80x100mm
Wheels: 46mm Diameter Mustard Lids
Drive Servos : Picos
Weapon Motor : NC-4 Stinger
Weapon ESC : Jes 110
Reciever : Hitec Feather
Power : 12.6v 340mah 3-cell Lipo pack
Chassis : 1 & 2mm Polycarbonate
Armor : None as such
Disk Info : 80mm Diamater, 35g, Stanley Knife blades
Status : Retired

Information:

Well, I was craving for another Ant, and after much consideration I decided to go with a Vertical Spinner, as it would be an engineering challenge, and also because there arn't many of them about, And boy was I right about it being an engineering challenge. I've changed things around on Zenith (Minor things) over and over again, and I still cant quite get it working correctly. The disk is fine, It spins up, and does very impressive stuff, It's just the gyro forces created by the disk drag me to the floor, or make me flip myself over. The trouble is the disk is only supported on one side, meaning it can, and will, still fall over to the other side, however, Zenith 1.1 will remedy this with 2 2mm polycarbonate supports, instead of one.
Powered by Create your own unique website with customizable templates.